This has been either a pump or controller related issue….so checked pumps for operation. Both issues are resolved, so able to run zones. Checked every zone on controller near south entrance running north along Wilson, and east along 50th. Checked and adjusted multiple rotors. Replaced multiple nozzles in rotors, as well as MP ROTATOR NOZZLES. Dug up and replaced broken sprayhead in island near Glen Isle on Glendale. Flagged one large impact sprinkler along Wilson that stopped turning…and one large rotor along fence that would not allow adjustments to radius. So went to DBC to get replacements. Returned to dig, but dirt was too hard to penetrate with shovel. Will soak area and replace on Monday. – Mark

No zones running upon entering area this morning. Checked pumps. Likely were off due to stuck valve on Saturday. Reset and pressured system. Dug up and replaced broken Rainbird impact sprinkler along Wilson with new 6″ rotor. Checked and adjusted, then ran zone with new rotor. Dug up and replaced broken rotor along 43rd next to fence. Checked, adjusted, and ran. Noticed additional rotor on zone along Wilson also stopped turning. Went to DBC to get new rotor. Dug up and replaced, checked/adjusted, ran zone. Also ran and adjusted rotors on other zones, checked stuck valve, and re-routed/reconnected controller wires that were pinched from front plate for wires. – Mark